220-1201

غلاف الملخص الشامل 1448

الملخص الشامل لـCompTIA A+ Core 1 1448

كل نقاط الاختبار في ملف PDF من 40 صفحة، مرتبة من الوحدة الأكبر وزنًا إلى الأصغر. الفصول الثلاثة الأولى وحدها نحو 76% من أسئلة الاختبار.

  • 40الصفحات
  • 90النقاط الأساسية
  • 40الأخطاء الشائعة
  • 70بطاقات المراجعة

خريطة الملخص

كل فصل وحدة من وحدات الاختبار. الترتيب حسب وزن الوحدة في الاختبار الحقيقي.

الفصلالوحدةالوزنأسئلة الاختبارنقاط الملخص
1استكشاف أخطاء الأجهزة والشبكات28%2518
2الأجهزة والمكونات25%2218
3الشبكات23%2118
4الأجهزة المحمولة13%1218
5المحاكاة الافتراضية والحوسبة السحابية11%1018

مصدر الأوزان

الفصل الأول كاملًا: استكشاف أخطاء الأجهزة والشبكات

28% من الاختبار، نحو 25 سؤالًا. هذه نقاطه الأساسية كما في الملخص.

  1. A beep code is a tone or series of tones with pauses during POST. The service manual gives the meaning per vendor, and one example is 3 short beeps and 1 long beep for a DRAM memory error: reseat the memory modules, then replace them.
  2. If the computer shows 'incorrect memory size during POST', the documented order of action is to run the memory tests, then replace the memory module, then the system board.
  3. After a BIOS update, a battery disconnect or replacement (including the CMOS battery) or a memory swap, the first boot runs a complete memory training. The screen may stay blank for about 5 to 10 minutes. Keep the device on power and avoid a forced shutdown.
بقية الفصل الأول على هذه الصفحة
  1. A failed BIOS update, such as one interrupted by a forced shutdown, can leave the system unable to boot into Windows. The BIOS update must be finished using the vendor's recovery process, so keep the device on power during updates.
  2. An RTC reset returns BIOS settings to defaults and resets the system date and time. Service Tag, Asset Tag and admin or system passwords are listed as unaffected by it in one manufacturer's manual.
  3. When a stop (blue screen) error appears, general steps from the vendor guidance are to update drivers, BIOS and firmware, run hardware and memory tests, scan for malware and keep 10 to 15 percent of the disk free.
  4. A Windows boot problem is troubleshooted with recovery methods one at a time, starting with Safe mode, and the error INACCESSIBLE_BOOT_DEVICE (STOP 0x7B) is listed as a boot-device error.
  5. RAID 0 uses data striping on two or more drives for throughput with no redundancy. RAID 1 mirrors data on pairs of drives. RAID 5 uses striping with distributed parity across three or more drives. RAID 10 combines RAID 1 and RAID 0.
  6. Fault tolerance means the data on the virtual drive stays complete even after a drive fails. A hot spare is a drive kept by the controller and used only when another drive fails, and it rebuilds the array. A hot swap works only if the backplane and enclosure support it.
  7. A SMART predictive failure alert means the drive should be replaced. A RAID controller can use a SMART error to start a Replace operation to a hot spare before the drive is marked as failed, which avoids a Degraded status.
  8. chkdsk checks a volume for logical and physical errors. With no parameters it only displays status. /f fixes errors, and /r locates bad sectors and recovers readable data and includes /f. It needs an administrator command prompt.
  9. For a 'no signal' display symptom, the checks are the cable connection, the input source, trying alternate ports and updating drivers. For poor image quality, check cable quality, resolution settings, cable length and interference.
  10. To tell hardware from software on a laptop screen, enter the BIOS setup. If the display is still faulty there, the screen hardware may be defective. If it looks normal in the BIOS, check the graphics driver and settings.
  11. Li-ion battery precautions from a laptop manual: discharge the battery before removal, and do not crush, drop, bend, puncture, apply pressure to, heat or disassemble it, and do not pry on it with tools.
  12. After a display is replaced on a touch device, a touch calibration tool is run. If calibration fails, reboot and try again, and persistent failure may mean the display is faulty.
  13. A 'no IP address' network problem can be checked in the adapter properties. A static setup needs a unique IP address in the network's range, a subnet mask, a default gateway and DNS servers.
  14. Cat 5e is rated 100 MHz, Cat 6 250 MHz and Cat 6A 500 MHz. Cat 6A supports 10GBASE-T to 100 m, while Do not assume Cat 6 does the same.
  15. Laser quality faults: white streaks can come from dirty LED heads or foreign material, colored streaks from corona wires or the toner cartridge, ghosting can be linked to low humidity or the drum unit, and light prints can come from low toner or the wrong paper type setting. Inkjet banding is handled by a nozzle check, head cleaning and head alignment.

أخطاء شائعة في هذا الفصل

  • Do not assume a dead PC needs a new power supply. Check the power cord, the power switch and the board's power connectors first.
  • A hardware error code or beep pattern means different things on different brands. Look it up for the stated vendor instead of using one universal table.
  • RAID 0 is not fault tolerant. It has no redundancy, so a single failed drive loses the array.
  • A RAID 5 array needs at least three drives. Two-drive arrays are RAID 0 or RAID 1.
  • A hot spare must be part of the array before a drive fails. It is not added after the failure.
  • chkdsk without parameters only reports the volume status and fixes nothing. The /f and /r switches fix errors, and /r adds a bad-sector scan on top of /f.
  • Cat 6A is the category documented for 10GBASE-T to 100 m. Do not assume Cat 6 or Cat 5e reaches 10 Gbps over the same distance.
  • Do not treat inkjet and laser fixes as interchangeable. A nozzle check and head cleaning belong to inkjets, while drums and toner cartridges belong to laser printers.

بقية الفصول في الملخص الكامل

اشترِ الآن · 34 ر.س

شراء واحد · وصول دائم · معه الملخص الشامل

خطة مراجعة 7 أيام

وزّعنا الفصول على 6 أيام حسب وزنها حتى يتقارب حمل كل يوم، واليوم السابع لاختبار كامل.

  1. اليوم 1 · 28% من الاختبار

    الفصل 1: استكشاف أخطاء الأجهزة والشبكات

  2. اليوم 2 · 25% من الاختبار

    الفصل 2: الأجهزة والمكونات

  3. اليوم 3 · 23% من الاختبار

    الفصل 3: الشبكات

  4. اليوم 4 · 13% من الاختبار

    الفصل 4: الأجهزة المحمولة

  5. اليوم 5 · 11% من الاختبار

    الفصل 5: المحاكاة الافتراضية والحوسبة السحابية

  6. اليوم 6

    اختبار تجريبي كامل: 90 سؤالًا في 90 دقيقة، ثم مراجعة «أخطاء شائعة» في الوحدات التي خسرت فيها.

قبل أن تقرأ: اعرف درجتك اليوم

10 أسئلة مجانية من أهم الوحدات، بدون تسجيل. تعرف بعدها من أي فصل تبدأ.

جرّب 10 أسئلة مجانية واعرف مستواك

لمحة من كل فصل

أول ثلاث نقاط من كل فصل كما تظهر في الملخص.

الفصل 1: استكشاف أخطاء الأجهزة والشبكات

  • A beep code is a tone or series of tones with pauses during POST…
  • If the computer shows 'incorrect memory size during POST', the documented order of action…
  • After a BIOS update, a battery disconnect or replacement (including the CMOS battery) or…

الفصل 2: الأجهزة والمكونات

  • Cat 5e is rated to 100 MHz and Cat 6 to 250 MHz. Cat…
  • T568A and T568B are both straight-through wiring schemes. They differ only in the positions…
  • HDMI 1.4 supports 4K at 30 Hz, HDMI 2.0 supports 4K at 60 Hz…

الفصل 3: الشبكات

  • 2.1
  • 2.1
  • 2.1

الفصل 4: الأجهزة المحمولة

  • Before working inside a laptop
  • Pull a cable by its connector or pull-tab, not the cable. Press in the…
  • Use only the battery designed for that specific computer model; batteries from other models…

الفصل 5: المحاكاة الافتراضية والحوسبة السحابية

  • A virtual machine is a software emulation of a physical computer. It runs as…
  • A hypervisor, also called a virtual machine monitor (VMM), logically separates VMs, so a…
  • Virtualization improves resource use, because one physical server can run several workloads instead of…

الملخص كاملًا مع الوصول الدائم

الملخص كاملًا (40 صفحة) يأتي مع الوصول الدائم لهذا الاختبار، ومعه كل الأسئلة والاختبارات التجريبية الكاملة. الفصل الأول مجاني للجميع.

أسئلة عن الملخص

هل الملخص مجاني؟

الفصل الأول مجاني للقراءة على صفحة الملخص. الملخص كاملًا يأتي مع الوصول الدائم لهذا الاختبار، ولا يشمله وصول 7 أيام.

هل يناسب اختبارات 1448؟

نعم. أوزان الوحدات ومعلومات الاختبار مكتوبة وفق آخر ما نشرته الجهة المنظمة، وتاريخ آخر تحقق مكتوب في الملخص. إذا تغيّرت المعايير نحدّث الملف، ومن اشترى يحمّل النسخة الجديدة.

هل في الملخص أسئلة؟

لا. الملخص للنقاط والأخطاء الشائعة فقط؛ قياس الدرجة والتدريب حسب نقاط الضعف والاختبارات التجريبية الكاملة على الموقع.

هل يُقرأ على الجوال؟

نعم. الصفحات بحجم A5 وعمود واحد، والفصول مرتبطة بالفهرس.

عدد الصفحات
40
الإصدار
1448هـ · 2026–2027
اللغة
العربية
آخر تحديث

العودة إلى صفحة شهادة CompTIA A+ Core 1 (220-1201)

CompTIA A+ Core 1

التحضير الكامل للاختبار

كل هذا في شراء واحد.

  • جلسات تدريب تكميلي بتوقيت90 سؤالًا في 90 دقيقة. تخرج بدرجتك الكلية ودرجة كل وحدة.
  • تدريب على كل وحدة572 سؤال، لكل خيار شرحه ومصدره. تبدأ بأضعف وحداتك.
  • الملخص الشامل 1448 (PDF)مرتب حسب وزن كل وحدة في الاختبار. مع الوصول الدائم فقط.

اختر مدة الوصول

خطوة واحدة قبل الدفع

سجّل الدخول بحساب Google ثم تنتقل مباشرة إلى صفحة الدفع.

اعرف درجتك مجانًاالتحضير الكامل